All Recalls

The reason for recall is the meters may show an incorrect measurement unit (mmol/L rather than mg/dL) and may result in the wrong unit of measure. Which may subsequently cause an error in interpreting a result as approximately 18 times lower that the actual blood glucose. Potential immediate health consequences of the glucose meter providing a reading in the wrong units of measurement (UOM) may result in inappropriate rescue therapy for presumed hypoglycemia including urgent and repeat administration of carbohydrates. This in turn could lead to frequent episodes of hyperglycemia which is unrecognized and undertreated.Long range consequences of continued use of the affected meters could include mismanagement of the patient s diabetes for longer periods of time potentially resulting in a major health event (in general persistent and/or severe hyperglycemia) that may lead them to seek medical attention, and depending on the duration of hyperglycemia, could contribute to the development of microvascular (i.e., retinopathy, neuropathy, nephropathy) and/or macrovascular (i.e., myocardial infarction, ischemic stroke) complications of diabetes and could lead to fetal damage (abnormal fetal growth and altered organ development and maturation, fetal hypoxemia, spontaneous abortion, and congenital anomalies) in pregnant women. This issue was identified by three initial consumer complaints, with reports that the meters were presenting the incorrect unit of measure.

Short circuit in the power supply unit (PSU) of the Touch Display may lead to overheating and fire

Potential for manufacturing defect. Weld crack led to devices failing at the leak check step in manufacturing.

Potential for manufacturing defect. Weld crack led to devices failing at the leak check step in manufacturing.

41 mm acetabular outer heads were potentially assembled with a 42 mm locking ring, may lead to joint instability leading requiring surgical intervention

Potential for manufacturing defect. Weld crack led to devices failing at the leak check step in manufacturing.

Short circuit in the power supply unit (PSU) of the Touch Display may lead to overheating and fire

Potential for manufacturing defect. Weld crack led to devices failing at the leak check step in manufacturing.

GE HealthCare has become aware of the potential for loss of monitoring on CARESCAPE Canvas 1000, CARESCAPE Canvas Smart Display, and certain versions of CARESCAPE B850 and CARESCAPE B650 monitors if, following the replacement of the CPU timekeeper battery, a mains power loss occurs during active monitoring. In the unlikely event that this occurs, it can result in the displays or monitors not turning on, after the mains power is restored. This can result in a delay in recognizing changes in patient condition until a replacement monitor is connected.

Short circuit in the power supply unit (PSU) of the Touch Display may lead to overheating and fire

Tip holder portion of the scaler tip assembly may have an oversized condition that will not allow the scaler tip to stay seated in the holder may cause injury

Potential for manufacturing defect. Weld crack led to devices failing at the leak check step in manufacturing.

Short circuit in the power supply unit (PSU) of the Touch Display may lead to overheating and fire

Short circuit in the power supply unit (PSU) of the Touch Display may lead to overheating and fire

Potential for manufacturing defect. Weld crack led to devices failing at the leak check step in manufacturing.

There is a potential manufacturing defect which can lead to electrical leakage in the sensing circuit which causes a system malfunction and requires a revision surgery to replace the IPG,

Potential for there to be a fluid ingress into the handle of the harvesting tool, which may lead to the device not providing cautery or providing cautery when not intended.

Potential for manufacturing defect. Weld crack led to devices failing at the leak check step in manufacturing.

Product labels state the incorrect expiration dates that extends beyond their true expiration date

Potential for coils to heat up and harm patients (burn).