95,089 total recalls in our database
When creating 3D plans using either MU or Dose weighting modes, if the user changes the Physician's Intent Rx Dose and/or the number of fractions, and then modifies the wedge angle, the MU value is scaled incorrectly.
Banyan Medical
Potential lack of assurance of sterility
The detectors on the Symbia S and Symbia T camera systems are supported and moved horizontally and vertically by four linear bearing cars. There is a potential for the linear bearing car to fail allowing the ball bearings to fall out.
Foreign material found within the driveline connector of the HVAD Pump that could cause increased impedance resulting in electrical faults.
GE Healthcare Surgery announces a voluntary field action for the OEC Brivo 715 Prime, OEC Brivo 685 Essential, and OEC Brivo 865 Advance because the circuit board that controls vertical motion of the C-arm may fail, resulting in the C-Arm moving up or down without command.
The product is being recalled due to a labeling error. The Gripper Graspers are labeled as Johans Graspers and the Johans Graspers are labeled as Gripper Graspers.
RAYSEARCH LABORATORIES AB
For a treatment plan consisting of multiple beam sets, the table for ROI plan dose statistics in the report may show the statistics for a beam set dose. The error can only be triggered when using a report template where statistics for a beam set dose is included as the last dose statistics prior to the plan dose statistics.
Old revisions and new revisions of the soft tissue sleeve and recon targeting arm are not interchangeable, as the new revision tissue sleeve will not fit into the old revision targeting arm. The old revision tissue sleeve has too much clearance with new revision targeting arm. Risks of encountering the affected product include: the correct instrument may not be readily available for the procedure causing the surgeon to complete the procedure by hand; or a delay in surgery greater than 30 minutes may occur while another Recon Targeting Arm or Recon Soft tissue Sleeve is located or while the surgeon completes the procedure by hand.
CONMED received complaints of damage to the CS-023 electrodes shaft insulation which could result in burn marks on the shaft. If the shaft insulation is damaged in any way, it could increase the risk of patient burn.
The product is being recalled due to a labeling error. The Gripper Graspers are labeled as Johans Graspers and the Johans Graspers are labeled as Gripper Graspers.
Surgical Specialties Mexico S DE RL DE CV
Surgical Specialties Mexico is recalling the BioSentry Track Sealant System due to the potential for an open seal on the product package.
Non-conforming component caused arms of TMM4 Stretcher chair to no longer meet design specifications.
A&D may have shipped blood pressure monitors that were not labeled for use with small cuff.
Husqvarna Consumer Outdoor Products N.A. Inc., of Charlotte, N.C.
The operator presence control bar can malfunction and cause the engine and blades to continue to operate when they should shut off, posing a laceration hazard to the operator.
Unknown Manufacturer
The rice/slow cooker's improperly installed wiring can cause electrical shorting in the unit, posing fire and electric shock hazards.
Unknown Manufacturer
The dive computer can malfunction and display an incorrect reading to the diver, posing a drowning and injury hazard due to decompression sickness.
Unknown Manufacturer
The ski boots can inadvertently switch from "ski" to "walk" mode, the boots' upper cuffs can separate, and in the Khion Carbon model, the carbon boot shell can crack, posing a fall hazard and risk of injury to the consumer.
L'echarpe Porte-bonheur Inc., of Canada
The carriers' side strap can loosen unexpectedly from the buckle, posing a fall hazard to the child in the carrier.
LF Products, of Singapore
Screws on the barstools can loosen, posing a fall hazard to the user.
Unknown Manufacturer
The light cube's lithium polymer battery can overheat and catch fire, posing a fire hazard.