Otto Bock Healthcare Products GmbH Genium X3 Model Number: 3B5-2, Manufacturer Otto Bock Healthcare Products GmbH. Intended to be used solely for lower limb prosthetic fittings.
Class I - DangerousWhat Should You Do?
- Check if you have this product: Serial Number 201528049, manufactured on 01 July 2015
- Do not eat it: Even if it looks and smells fine, do not consume this product.
- Throw it away or return it: You can return the product to the store for a full refund.
- Seek medical attention if needed: If you've consumed this product and feel unwell, contact your doctor immediately.
- Report problems: Report any issues to the FDA's Safety Reporting Portal.
⚠️ Emergency: If you experience severe symptoms after consuming this product, call 911 or Poison Control at 1-800-222-1222.
Recall Details
- Company:
- Otto Bock Healthcare Product
- Reason for Recall:
- Otto Bock Healthcare Products GmbH is recalling the new Genium X3 knee joint prosthesis due to issues with the resistance-control of the hydraulics, which may fail under conditions.
- Classification:
- Class I - Dangerous
Dangerous or defective products that predictably could cause serious health problems or death.
- Status:
- terminated
Product Information
Full Description:
Otto Bock Healthcare Products GmbH Genium X3 Model Number: 3B5-2, Manufacturer Otto Bock Healthcare Products GmbH. Intended to be used solely for lower limb prosthetic fittings.
Product Codes/Lot Numbers:
Serial Number 201528049, manufactured on 01 July 2015
Distribution:
Distributed in: OH
Official Source
Always verify recall information with the official FDA source:
View on FDA.govFDA Recall Number: Z-2438-2015
Related Recalls
OTTO BOCK Kenevo knee joints Model 3C60=ST
Otto Bock Healthcare Product
Otto Bock Healthcare Products GmbH has identified a design issue through extended durability testing where the pylon clamping mechanism has the potential to cause damage to the pylon. When used longer than 1.45 million cycles (which represents approximately 2.3 years of use of the knee joint under heavy usage conditions), AND the pylon clamp is overtightened according to the labeled torque specification, AND the patient weighs at most 125kg it may be remote that the pylon breaks, and causing the patient to fall. There have been no failures or complaints reported directly attributed to the failure mode collapsed pylon . In the US Market and in Canada, labeling requires a condition based service at three years. In the rest of the world, a mandatory two year service interval is specified. Only the devices in distribution in the United States and Canada are affected by this action.
OTTO BOCK Kenevo knee joints Model 3C60
Otto Bock Healthcare Product
Otto Bock Healthcare Products GmbH has identified a design issue through extended durability testing where the pylon clamping mechanism has the potential to cause damage to the pylon. When used longer than 1.45 million cycles (which represents approximately 2.3 years of use of the knee joint under heavy usage conditions), AND the pylon clamp is overtightened according to the labeled torque specification, AND the patient weighs at most 125kg it may be remote that the pylon breaks, and causing the patient to fall. There have been no failures or complaints reported directly attributed to the failure mode collapsed pylon . In the US Market and in Canada, labeling requires a condition based service at three years. In the rest of the world, a mandatory two year service interval is specified. Only the devices in distribution in the United States and Canada are affected by this action.