NX3 Try-In Gel. The product is used as a tooth shade resin material.
Class I - DangerousWhat Should You Do?
- Check if you have this product: Part Number 33660. Syringe Lot Number 4580333. Autobag Lot Number 4584609.
- Do not eat it: Even if it looks and smells fine, do not consume this product.
- Throw it away or return it: You can return the product to the store for a full refund.
- Seek medical attention if needed: If you've consumed this product and feel unwell, contact your doctor immediately.
- Report problems: Report any issues to the FDA's Safety Reporting Portal.
⚠️ Emergency: If you experience severe symptoms after consuming this product, call 911 or Poison Control at 1-800-222-1222.
Recall Details
- Company:
- Kerr/Pentron, DBA Kerr Corporation and Pentron Clinical
- Reason for Recall:
- Kerr Corporation is voluntarily recalling one lot of NX3 Try-In Gel, because some of the NX3 Try-In Gel syringes in the affected lot contain a different product material. The material in the affected syringe does not match the shade of the cement as it is labeled.
- Classification:
- Class I - Dangerous
Dangerous or defective products that predictably could cause serious health problems or death.
- Status:
- terminated
Product Information
Full Description:
NX3 Try-In Gel. The product is used as a tooth shade resin material.
Product Codes/Lot Numbers:
Part Number 33660. Syringe Lot Number 4580333. Autobag Lot Number 4584609.
Official Source
Always verify recall information with the official FDA source:
View on FDA.govFDA Recall Number: Z-2259-2013
Related Recalls
An issue within production process used to package trial kits let to the inclusion of the incorrect bonding agent for the kit. Use of the incorrect bonding agent may lead to increased risk of bond failures.
Immersion time stated on the bottle is 45 minutes while the product instructions say 90 minutes.
Kerr Corporation is initiating this recall because raw material used to produce the Maxcem Elite is causing the material to prematurely polymerize in the syringe. The product could be difficult to extrude or demonstrate a shorter work-time as the material may prematurely set prior to placing restorations on the tooth or core build-up. As a result, the restoration may not be seated properly.