HLD System, Model 610, Medical Device Cleaning and High Level Disinfection Washer/Pasteurizer.
Class I - DangerousWhat Should You Do?
- Check if you have this product: 610601, 610603, 610703, 610704, 610705, 610707, 610708, 610802, 610803, 610804, 610901, 610903, 610904, 610905, 611001, 611002, 611004, 611101, 611102, 611103, 611201, 611202, 611203, 610902L, 611204.
- Do not eat it: Even if it looks and smells fine, do not consume this product.
- Throw it away or return it: You can return the product to the store for a full refund.
- Seek medical attention if needed: If you've consumed this product and feel unwell, contact your doctor immediately.
- Report problems: Report any issues to the FDA's Safety Reporting Portal.
⚠️ Emergency: If you experience severe symptoms after consuming this product, call 911 or Poison Control at 1-800-222-1222.
Recall Details
- Company:
- Cenorin, LLC
- Reason for Recall:
- The temperature sensor/control system in the HLD Systems Model 610 may provide a false temperature reading. This caused the water to remain at ambient temperature throughout the pasteurization cycle rather than using hot water.
- Classification:
- Class I - Dangerous
Dangerous or defective products that predictably could cause serious health problems or death.
- Status:
- terminated
Product Information
Full Description:
HLD System, Model 610, Medical Device Cleaning and High Level Disinfection Washer/Pasteurizer.
Product Codes/Lot Numbers:
610601, 610603, 610703, 610704, 610705, 610707, 610708, 610802, 610803, 610804, 610901, 610903, 610904, 610905, 611001, 611002, 611004, 611101, 611102, 611103, 611201, 611202, 611203, 610902L, 611204.
Official Source
Always verify recall information with the official FDA source:
View on FDA.govFDA Recall Number: Z-1995-2014
Related Recalls
There is a supplier quality issue with the terminal blocks which may cause the terminal block to overheat, char and/or burn.
Dryer unit not heating. Manufacturing issue causes the terminal block to overheat, char and/or burn.
Dryer unit not heating. Manufacturing issue causes the terminal block to overheat, char and/or burn.