Stryker 1,5/1,7MM DYNAMIC MESH- STD-MEDIUM-Intended for the reconstruction, stabilization and rigid fixation of the bony areas of the cranial skeleton. Catalog Number: 56-90614
Class I - DangerousWhat Should You Do?
- Check if you have this product: GTIN: 07613327123197 Lot Number: 270644
- Do not eat it: Even if it looks and smells fine, do not consume this product.
- Throw it away or return it: You can return the product to the store for a full refund.
- Seek medical attention if needed: If you've consumed this product and feel unwell, contact your doctor immediately.
- Report problems: Report any issues to the FDA's Safety Reporting Portal.
⚠️ Emergency: If you experience severe symptoms after consuming this product, call 911 or Poison Control at 1-800-222-1222.
Recall Details
- Company:
- Stryker Leibinger GmbH & Co. KG
- Reason for Recall:
- Mislabeled: Product labeled 56-90614 (90x90 Gold Mesh), was actually 56-90314 (90x90 Blue Mesh), may cause a delay in procedure
- Classification:
- Class I - Dangerous
Dangerous or defective products that predictably could cause serious health problems or death.
- Status:
- ongoing
Product Information
Full Description:
Stryker 1,5/1,7MM DYNAMIC MESH- STD-MEDIUM-Intended for the reconstruction, stabilization and rigid fixation of the bony areas of the cranial skeleton. Catalog Number: 56-90614
Product Codes/Lot Numbers:
GTIN: 07613327123197 Lot Number: 270644
Official Source
Always verify recall information with the official FDA source:
View on FDA.govFDA Recall Number: Z-1785-2024
Related Recalls
Unreleased software was installed on customer systems resulting in the visual feedback on the screen to show the points to be off from the physical reference point of the pointer or suction.
Patient-Fitted Temporomandibular (TMJ) Reconstruction Prosthesis
Stryker Leibinger GmbH & Co. KG
Device was shipped without having regulatory approval.
MEDPOR Titan OFW - MTB - Right - 1.0mm, Catalog number 81032
Stryker Leibinger GmbH & Co. KG
Inside the packaging of one reported item a non-conforming product was found. Contrary to the design, the barrier layer was manufactured on the inferior side of the implant versus the superior side.