HORIZON Ez Arm (Part of the HORIZON TMS Therapy System.)

Class I - Dangerous

What Should You Do?

  1. Check if you have this product:
    Product #: 5162-00 Serial #'s: 55308/001, 55308/002, 55310/001, 55310/002, 55446/001, 55446/002, 55447/001, 55447-002, 55631-001, 55631-002, 55631-003, 55631-004, 55632/001, 55632/002, 55632/003, 55632/004, 55841/001, 55841-002, 55841-003, 55841-004, 55842/001, 55842/002, 55842/003, 55842/004, 55843-001, PLT00015/001 and PLT00015/002
  2. Do not eat it: Even if it looks and smells fine, do not consume this product.
  3. Throw it away or return it: You can return the product to the store for a full refund.
  4. Seek medical attention if needed: If you've consumed this product and feel unwell, contact your doctor immediately.
  5. Report problems: Report any issues to the FDA's Safety Reporting Portal.

⚠️ Emergency: If you experience severe symptoms after consuming this product, call 911 or Poison Control at 1-800-222-1222.

Recall Details

Company:
The Magstim Company Limited
Reason for Recall:
A stray strand of stainless-steel cable may protrude from the heat shrink sleeving on the Balance Cable of the Ez Arm.
Classification:
Class I - Dangerous

Dangerous or defective products that predictably could cause serious health problems or death.

Status:
ongoing

Product Information

Full Description:

HORIZON Ez Arm (Part of the HORIZON TMS Therapy System.)

Product Codes/Lot Numbers:

Product #: 5162-00 Serial #'s: 55308/001, 55308/002, 55310/001, 55310/002, 55446/001, 55446/002, 55447/001, 55447-002, 55631-001, 55631-002, 55631-003, 55631-004, 55632/001, 55632/002, 55632/003, 55632/004, 55841/001, 55841-002, 55841-003, 55841-004, 55842/001, 55842/002, 55842/003, 55842/004, 55843-001, PLT00015/001 and PLT00015/002

Distribution:

Distributed in: CA, MA, MN, PA, TX, VA, WI, WA

Official Source

Always verify recall information with the official FDA source:

View on FDA.gov

FDA Recall Number: Z-0836-2019

Related Recalls

A small number of Neurosign 100 Intraoperative Nerve Monitors may have been dispatched without being configured appropriately for the supply mains within the target Country. The specific deficiency includes: 1. Onboard voltage selector set to 240V (European Standard), versus 120V requirement for the United States and Canada. 2. Fuses installed in the Power Entry Module (PEM) 2xT315mAL (240V Standard), versus the 2xT630mAL requirement for a 120V mains supply.

Dec 8, 2020 Diagnostic Equipment View Details →

It was identified that there is a potential for the Stim Interconnecting high Voltage Cable located at the rear of the Rapid2 and Horizon power supply unit to fail.

Mar 23, 2020 Infusion Pumps Nationwide View Details →