CARDIOSAVE Intra-Aortic Balloon Pump An electromechanical system used to inflate and deflate intra-aortic balloons. It provide temporary support to the left ventricle via the principle of counterpulsation.
Class I - DangerousWhat Should You Do?
- Check if you have this product: 510K K112372 Device Listing Number D132687 US Customer IABPs CA202159K1 CA202167K1 CA203492L1 CA203494L1 International Customer IABPs CA203486L1 CA202155K1 CA202161K1 CA203487L1 CA203490L1 CA203507L1 CA204330L1 CA204328L1 CA203505L1 International Company Owned IABPs CA204327L1 CA202150K1 CA203506L1 CA204324L1 CA204326L1 CA202163K1 CA202169K! CA203497L1 CA203498L1 CA203496L1 CA203503L1 CA203488L1 CA203493L1 CA203508L1 CA204337L1 CA203502L1
- Do not eat it: Even if it looks and smells fine, do not consume this product.
- Throw it away or return it: You can return the product to the store for a full refund.
- Seek medical attention if needed: If you've consumed this product and feel unwell, contact your doctor immediately.
- Report problems: Report any issues to the FDA's Safety Reporting Portal.
⚠️ Emergency: If you experience severe symptoms after consuming this product, call 911 or Poison Control at 1-800-222-1222.
Recall Details
- Company:
- Maquet Cardiovascular, LLC
- Reason for Recall:
- In the Cardiosave Intra-aortic Balloon Pump, there is a possibility that the coiled cord assembly, a prominent connector cord between the Cardiosave IABP housing and the dual display head which secured atop the IABP may fail as a result of mishandling.
- Classification:
- Class I - Dangerous
Dangerous or defective products that predictably could cause serious health problems or death.
- Status:
- terminated
Product Information
Full Description:
CARDIOSAVE Intra-Aortic Balloon Pump An electromechanical system used to inflate and deflate intra-aortic balloons. It provide temporary support to the left ventricle via the principle of counterpulsation.
Product Codes/Lot Numbers:
510K K112372 Device Listing Number D132687 US Customer IABPs CA202159K1 CA202167K1 CA203492L1 CA203494L1 International Customer IABPs CA203486L1 CA202155K1 CA202161K1 CA203487L1 CA203490L1 CA203507L1 CA204330L1 CA204328L1 CA203505L1 International Company Owned IABPs CA204327L1 CA202150K1 CA203506L1 CA204324L1 CA204326L1 CA202163K1 CA202169K! CA203497L1 CA203498L1 CA203496L1 CA203503L1 CA203488L1 CA203493L1 CA203508L1 CA204337L1 CA203502L1
Distribution:
Distributed in: ID
Official Source
Always verify recall information with the official FDA source:
View on FDA.govFDA Recall Number: Z-0662-2013
Related Recalls
Reports of out-of-box failures discovered during the limited launch phase. Failure modes included angled deformity at the attachment site of the Harvesting Tool Jaws and the distal end of the Harvesting Tool Shaft, jaws not fully closed out of box, and heater wire lifted/flexed away from jaws.
Heartstring III Proximal Seal System. Intravascular anastomosis occluder.
Maquet Cardiovascular
Three failure modes have been identified: failure of the Heartstring Seal to load, failure of the Heartstring Seal to deploy into the aortotomy, and failure of the deployed Heartstring Seal to provide adequate hemostasis.
Heartstring III Proximal Seal System, 3.8 MM. Intravascular anastomosis occluder.
Maquet Cardiovascular
Three failure modes have been identified: failure of the Heartstring Seal to load, failure of the Heartstring Seal to deploy into the aortotomy, and failure of the deployed Heartstring Seal to provide adequate hemostasis.