ORTHOFIX Catalogue Number: ref 1-1100301,DRILL BIT Diameter 3.2 MM L. 200 MM TIN COATED- QUICK CONNECT, RX ONLY, Non Sterile, UDI: (01)18033509856075
Class I - DangerousWhat Should You Do?
- Check if you have this product: Lot # B1203608, B1210965, B1211752, B1214172,B1218793, 300241,300240,273169
- Do not eat it: Even if it looks and smells fine, do not consume this product.
- Throw it away or return it: You can return the product to the store for a full refund.
- Seek medical attention if needed: If you've consumed this product and feel unwell, contact your doctor immediately.
- Report problems: Report any issues to the FDA's Safety Reporting Portal.
⚠️ Emergency: If you experience severe symptoms after consuming this product, call 911 or Poison Control at 1-800-222-1222.
Recall Details
- Company:
- Orthofix Srl
- Reason for Recall:
- As a result of complaint investigations it was determined that batches of drill bits have a geometrical detail that does not correspond to the intended design. This could result in lower cutting performance.
- Classification:
- Class I - Dangerous
Dangerous or defective products that predictably could cause serious health problems or death.
- Status:
- terminated
Product Information
Full Description:
ORTHOFIX Catalogue Number: ref 1-1100301,DRILL BIT Diameter 3.2 MM L. 200 MM TIN COATED- QUICK CONNECT, RX ONLY, Non Sterile, UDI: (01)18033509856075
Product Codes/Lot Numbers:
Lot # B1203608, B1210965, B1211752, B1214172,B1218793, 300241,300240,273169
Distribution:
Nationwide distribution
Official Source
Always verify recall information with the official FDA source:
View on FDA.govFDA Recall Number: Z-0382-2020
Related Recalls
Retrospective; Their is the potential that implantable intramedullary lengthening nails may bend at the distal tail during insertion resulting in having to be replaced.
As a result of complaint investigations it was determined that batches of drill bits have a geometrical detail that does not correspond to the intended design. This could result in lower cutting performance.
As a result of complaint investigations it was determined that batches of drill bits have a geometrical detail that does not correspond to the intended design. This could result in lower cutting performance.