OptiLITE, Products for Laser Surgery, Model # CGH1080F, 800 micron single-use holmium fiber assembly with flat tip, Lot Number 21144, Sterilized by Sterrad Run 4149, This device is for single-use only, sterile, UDI: 00855430006036
Class I - DangerousWhat Should You Do?
- Check if you have this product: Lot # 21144, Use by 08/10/2021
- Do not eat it: Even if it looks and smells fine, do not consume this product.
- Throw it away or return it: You can return the product to the store for a full refund.
- Seek medical attention if needed: If you've consumed this product and feel unwell, contact your doctor immediately.
- Report problems: Report any issues to the FDA's Safety Reporting Portal.
⚠️ Emergency: If you experience severe symptoms after consuming this product, call 911 or Poison Control at 1-800-222-1222.
Recall Details
- Company:
- Xintec Corp
- Reason for Recall:
- It has been determined that a lot of fiber lasers were programmed incorrectly. As a result, the fibers from this lot will produce an error and will not allow the user to use the laser when it is plugged in.
- Classification:
- Class I - Dangerous
Dangerous or defective products that predictably could cause serious health problems or death.
- Status:
- terminated
Product Information
Full Description:
OptiLITE, Products for Laser Surgery, Model # CGH1080F, 800 micron single-use holmium fiber assembly with flat tip, Lot Number 21144, Sterilized by Sterrad Run 4149, This device is for single-use only, sterile, UDI: 00855430006036
Product Codes/Lot Numbers:
Lot # 21144, Use by 08/10/2021
Distribution:
Distributed in: PA, VA
Official Source
Always verify recall information with the official FDA source:
View on FDA.govFDA Recall Number: Z-0162-2020
Related Recalls
It has been determined that the reprocessing instructions may not provide sufficiently detailed information for the cleaning, disinfection and sterilization of the products listed below. The preliminary investigation indicates that validation data related to the reprocessing of these devices may not meet newly enacted standards.