LockTop Fireplace Damper and Cap sets
Class II - ModerateWhat Should You Do?
- Check if you have this product: See description
- Do not eat it: Even if it looks and smells fine, do not consume this product.
- Throw it away or return it: You can return the product to the store for a full refund.
- Report problems: Report any issues to the FDA's Safety Reporting Portal.
Recall Details
- Company:
- Fireplace Technologies
- Reason for Recall:
- April 18, 1995 Release # 95-104 WASHINGTON, D.C. -- CPSC, Fireplace Technologies Inc., of Louisville, Ky., is announcing a program to provide free kits to modify approximately 36,000 LockTop Fireplace Damper and Cap sets. The vent dampers might close if soot builds up and results in chimney fire. This could force smoke and flue gases back into the house, which may present a risk of death or injury from inhalation of smoke and carbon monoxide.Although no injuries have been reported, CPSC is aware of two incidents in which the vent closed during chimney fires, potentially exposing consumers to hazardous smoke and carbon monoxide.The box-shaped LockTop Fireplace Damper and Cap is 8 inches tall and has a hollow square, cast aluminum base ranging in size from 8 inches by 8 inches to 17 inches by 17 inches, depending on the model. The product's collapsible sides are connected to a solid cast aluminum lid.The device can be permanently mounted to the top of a chimney and functions as both a damper and a chimney cap. The products were sold through chimney sweeps and wood fuel appliance contractors from December 1989 to the present.Consumers who have a LockTop Fireplace Damper and Cap sets should contact the chimney sweep or contractor who installed the unit or call Fireplace Technologies at (800) 737-1067 for a free retrofit kit. The retrofit kit will be installed at no cost to the consumer and will prevent the vent from closing during chimney fires. All new LockTop Fireplace Damper and Cap sets purchased after May 15, 1995 will have the kit permanently incorporated into the unit
- Classification:
- Class II - Moderate
Products that might cause a temporary health problem, or pose a slight threat of a serious nature.
- Status:
- ongoing
Product Information
Full Description:
April 18, 1995 Release # 95-104 WASHINGTON, D.C. -- CPSC, Fireplace Technologies Inc., of Louisville, Ky., is announcing a program to provide free kits to modify approximately 36,000 LockTop Fireplace Damper and Cap sets. The vent dampers might close if soot builds up and results in chimney fire. This could force smoke and flue gases back into the house, which may present a risk of death or injury from inhalation of smoke and carbon monoxide.Although no injuries have been reported, CPSC is aware of two incidents in which the vent closed during chimney fires, potentially exposing consumers to hazardous smoke and carbon monoxide.The box-shaped LockTop Fireplace Damper and Cap is 8 inches tall and has a hollow square, cast aluminum base ranging in size from 8 inches by 8 inches to 17 inches by 17 inches, depending on the model. The product's collapsible sides are connected to a solid cast aluminum lid.The device can be permanently mounted to the top of a chimney and functions as both a damper and a chimney cap. The products were sold through chimney sweeps and wood fuel appliance contractors from December 1989 to the present.Consumers who have a LockTop Fireplace Damper and Cap sets should contact the chimney sweep or contractor who installed the unit or call Fireplace Technologies at (800) 737-1067 for a free retrofit kit. The retrofit kit will be installed at no cost to the consumer and will prevent the vent from closing during chimney fires. All new LockTop Fireplace Damper and Cap sets purchased after May 15, 1995 will have the kit permanently incorporated into the unit
Product Codes/Lot Numbers:
See description
Official Source
Always verify recall information with the official CPSC source:
View on CPSC.govCPSC Recall Number: 95104