🔍 RecallPedia

Hydro Air suction drain cover fittings

Class II - Moderate
🏠 Consumer Products Recalled: May 28, 1982 Hydro Air Electronics Nationwide

What Should You Do?

  1. Check if you have this product:
    See description
  2. Do not eat it: Even if it looks and smells fine, do not consume this product.
  3. Throw it away or return it: You can return the product to the store for a full refund.
  4. Report problems: Report any issues to the FDA's Safety Reporting Portal.

Recall Details

Company:
Hydro Air
Reason for Recall:
Entrapment
Classification:
Class II - Moderate

Products that might cause a temporary health problem, or pose a slight threat of a serious nature.

Status:
ongoing
Hazard:
Entrapment

Product Information

Full Description:

Hot Tub Suction Drain Fittings Recalled by Hydro Air NEWS from CPSC U.S. Consumer Product Safety Commission Office of Information and Public Affairs Washington, DC 20207 FOR IMMEDIATE RELEASE May 28, 1982 Release # 82-023 Recall Of Hot Tub, Spa, Whirlpool Suction Drain Fitting Because Of Hair Entrapment WASHINGTON, D.C. --The U.S. Consumer Product Safety Commission in cooperation with Hydro Air Industries Inc., Orange, California, today announced a voluntary recall of approximately 125,000 suction drain cover fittings for spas, hot tubs and whirlpools because of the danger of hair entrapment. Three incidents have occurred when pre-teenage girls put their heads under water and their long hair became entangled in the suction drain cover fitting. Two incidents resulted in death by drowning, and in one incident the victim was pulled free. Water is drawn from the spa through 3-5/8 inch plastic suction fitting or drain covers located on the wall of the spa l-3 inches from the bottom. A powerful strong suction exists at the water outlet suction fitting or drain cover when the high speed whirlpool suction is turned on. The Hydro Air suction drain cover fittings can be identified by the three slots on the face of the fitting cover. The middle slot measures 3/16 inches by l-1/2 inches and the two slots on either side measures 3/16 inches by l-1/4. These suction/drain cover fittings have been sold nationwide since 1979. Most sales occurred within California, Arizona, Texas and Florida. Consumers should immediately stop using their hot tubs, spas and whirlpools. They should contact the company responsible for the installation, or Hydro Air Industries, Inc. (1317 W. Grove, Orange, CA 92665, Telephone: 714-974-1920, call collect), to determine whether their unit has a defective suction/drain cover and to make arrangements for a free replacement.

Product Codes/Lot Numbers:

See description

Official Source

Always verify recall information with the official CPSC source:

View on CPSC.gov

CPSC Recall Number: 82023

Related Recalls