Heat Guns
Class I - DangerousWhat Should You Do?
- Check if you have this product: (About 300,000)
- Do not eat it: Even if it looks and smells fine, do not consume this product.
- Throw it away or return it: You can return the product to the store for a full refund.
- Seek medical attention if needed: If you've consumed this product and feel unwell, contact your doctor immediately.
- Report problems: Report any issues to the FDA's Safety Reporting Portal.
⚠️ Emergency: If you experience severe symptoms after consuming this product, call 911 or Poison Control at 1-800-222-1222.
Recall Details
- Company:
- Wagner Spray Tech Corp., of Minneapolis, Minn.
- Reason for Recall:
- An electrical component failure inside the heat guns can cause them to continue to produce heat after the power switch is turned off. This can melt the heat gun's plastic exterior, causing a burn if the heat gun is touched and ignite nearby combustibles, posing fire and burn hazards.
- Classification:
- Class I - Dangerous
Dangerous or defective products that predictably could cause serious health problems or death.
- Status:
- ongoing
- Hazard:
- An electrical component failure inside the heat guns can cause them to continue to produce heat after the power switch is turned off. This can melt the heat gun's plastic exterior, causing a burn if the heat gun is touched and ignite nearby combustibles, posing fire and burn hazards.
- Remedy:
- Consumers should immediately stop using the recalled heat guns and contact Wagner for a free replacement product.
Product Images
Product Information
Full Description:
The recalled heat guns emit hot air and are used for paint and flooring removal, defrosting freezers and water lines, bending plastic, hobbies, etc. Recalled models include the Milwaukee Heat Gun MHT3300, ACE HT3500 Heat Gun, and the Wagner Heat Gun HT3500 with date codes V300R through Z365R and A001R through A111R. The heat gun's name and model number are located on a black label on the bottom of the heat gun's barrel. The date code is stamped into the bottom of the handle near the power cord. The heat guns are black or yellow plastic and measure about 10 inches long, 8 inches high and 3 inches wide.
Product Codes/Lot Numbers:
(About 300,000)
Official Source
Always verify recall information with the official CPSC source:
View on CPSC.govCPSC Recall Number: 09243