DeWalt DW378G/DW378GT Framing Saws and DC300 Circular Saws
Class III - Low RiskWhat Should You Do?
- Check if you have this product: (About 97,000 framing saws and 37,000 circular saws)
- Do not eat it: Even if it looks and smells fine, do not consume this product.
- Throw it away or return it: You can return the product to the store for a full refund.
- Report problems: Report any issues to the FDA's Safety Reporting Portal.
Recall Details
- Company:
- DeWalt Industrial Tool Co., of Towson, Md.
- Reason for Recall:
- The lower blade guard can fail to close, leaving the blade exposed and presenting a laceration hazard to consumers.
- Classification:
- Class III - Low Risk
Products that are unlikely to cause any adverse health reaction, but violate FDA regulations.
- Status:
- ongoing
- Hazard:
- The lower blade guard can fail to close, leaving the blade exposed and presenting a laceration hazard to consumers.
- Remedy:
- Consumers should stop using the saws immediately and contact DeWalt for a free repair.
Product Images
Product Information
Full Description:
This recall involves DeWalt DW378G and DW378GT 7 ¼-inch framing saws with date codes 200301-49 through 200637-49. The model numbers for the framing saws are located on the side of the housing. The date code is located either on the name plate or under the handle near the power cord exit. Circular saws involved in this recall have model number DC300 with date codes 200601-49 through 200637-49. The model number on the circular saw is located on the name plate on the top of the motor housing. The date code on the circular saw is located on the underside of the motor housing. Framing saws marked with a "V" on the underside of the handle near the cord set and circular saws marked with a "V" on the underside of the motor housing or under the handle where the battery is inserted have already been repaired and are not involved in this recall.
Product Codes/Lot Numbers:
(About 97,000 framing saws and 37,000 circular saws)
Official Source
Always verify recall information with the official CPSC source:
View on CPSC.govCPSC Recall Number: 07026
Related Recalls
DEWALT DC608 Cordless Brad Nailers
DEWALT Industrial Tool Co., of Towson, Md.
The nailer can operate when the lock-off (safety) is in the locked position. Also, the nailer can operate when the trigger is not pulled and the contact trip is depressed. The unexpected ejection of a nail poses a serious injury hazard to consumers.
DEWALT DW744 Jobsite Table Saws
DEWALT Industrial Tool Co., of Towson, Md.
The pivot bracket on the saw can separate, which can misalign the blade and the fence and cause kick back. This poses a laceration hazard to consumers.
DEWALT DG2900 Portable Generators
DEWALT Industrial Tool Co., of Towson, Md.
A ground fault circuit interrupter (GFCI) installed on the generator could fail to operate properly, posing a risk of electric shock to consumers.