πŸ₯

Medical Devices Recalls

Medical equipment, implants, and diagnostic devices

38,779 Total Recalls

Voids in the seal or a partial seal results in an open channel and may compromise the sterility of the product

Mar 21, 2019 Other Medical Devices Nationwide View Details β†’

Continuous operation at very high tube output may result in increased wear of the radiation emitting components. This may occur when tube voltages of 125 kV are used for a long period, e.g. 30 minutes or more of continuous use. As a result, risk of premature failure of the Monoblock and loss of imaging X-rays.

Mar 18, 2019 Diagnostic Equipment Nationwide View Details β†’

Voids in the seal or a partial seal results in an open channel and may compromise the sterility of the product

Mar 21, 2019 Other Medical Devices Nationwide View Details β†’

There is no warning in the Elekta Unity manual for the administration of gadolinium-based or other contrast agents for imaging or image guidance purposes has not been validated.

Apr 3, 2019 Diagnostic Equipment Nationwide View Details β†’

There is a potential of fracture, bending or shearing of the driver.

Mar 28, 2019 Implants & Prosthetics Nationwide View Details β†’

Potential risk of scans being aborted when using the optional Dual Spiral Dual Engery mode due to a software issue found in syngo CT VB10A for the Siemens Healthineers CT scanners with a single X-ray tube.

Feb 14, 2019 Other Medical Devices Nationwide View Details β†’
Class I - Dangerous

The firm has confirmed complaints regarding signal drops on the cobas e 801 module after a ProCell II M bottle changeover, which may lead to incorrect medical decisions with respect to diagnostics and patient treatment.

Mar 15, 2019 Other Medical Devices Nationwide View Details β†’

During installation of certain Nuclear Medicine systems delivered with dismounted detectors, some detector screws may not have been secured correctly, leading to the possible loss of one detector mounting design redundancy.

Mar 20, 2019 Diagnostic Equipment View Details β†’

During installation of certain Nuclear Medicine systems delivered with dismounted detectors, some detector screws may not have been secured correctly, leading to the possible loss of one detector mounting design redundancy.

Mar 20, 2019 Diagnostic Equipment View Details β†’

Intermittent heat seal failures on the outer pouch of some EZ Derm products.

Mar 26, 2019 Diagnostic Equipment Nationwide View Details β†’

The flow rate test verification was not properly executed for certain Sigma Spectrum infusion pumps prior to release. The testing was performed for less than the required minimum run time. Improperly performed flow rate testing may not identify issues with pumps that could cause inaccuracies in flow rates which, in turn, could lead to over- or under- infusion. Potential risk to the patient depends on a number of factors including treatment and patient comorbidities. Depending on these factors, the patient could experience serious adverse health consequences.

Jun 21, 2018 Diagnostic Equipment Nationwide View Details β†’