AMT Initial Placement Dilator Set. Used to place gastrostomy devices.
Applied Medical Technology
Devices were labelled with the incorrect guidewire labelling.
🏥 Medical Devices • 15,203 recalls
Applied Medical Technology
Devices were labelled with the incorrect guidewire labelling.
Ortho-Clinical Diagnostics
VITROS Chemistry Products FS Diluent Pack 3, Lot 01-1645 may cause results to be negatively biased when used to dilute patient samples tested with VITROS Chemistry Products CRP Slides.
WOM World Of Medicine AG
Incorrect transponder data was written on the RFID tags triggers the error message E03, Tube Set lnvalid, may result in a delay of surgery
To limit the use of the Mega Soft Pads to patients aged 12 or older to mitigate the potential risk of patient burns identified with use of Mega Soft pads.
First Source
Potential for the bolt that secures the positioning arm to the gas spring to come loose and fall onto patient.
GE Medical Systems Information Technologies
Capacitors in certain Prucka 3 Amplifiers used with CardioLab / ComboLab systems could fail resulting in transient oscillations on the display and inability to view surface and intracardiac ECG waveforms.
Due to inadvertently disconnecting grounding cable of ultrasound system could result in electrical shock, electrical interference and/or equipment malfunction.
Thoratec Switzerland GMBH
Due to a component change, the console part of a circulatory support system may not conform to the IEC 61000-4-5 standard, so if subjected to a power surge above 1.8kV and up to 2.0 kV, the console may shut down completely without alarm, pumping would cease, and the patient would have to be switched to a backup circulatory support system.
GE HealthCare has become aware of the potential for loss of monitoring on CARESCAPE Canvas 1000, CARESCAPE Canvas Smart Display, and certain versions of CARESCAPE B850 and CARESCAPE B650 monitors if, following the replacement of the CPU timekeeper battery, a mains power loss occurs during active monitoring. In the unlikely event that this occurs, it can result in the displays or monitors not turning on, after the mains power is restored. This can result in a delay in recognizing changes in patient condition until a replacement monitor is connected.
Siemens Medical Solutions USA
Short circuit in the power supply unit (PSU) of the Touch Display may lead to overheating and fire
Siemens Healthcare Diagnostics
Siemens Healthineers has identified an issue with the RAPIDPoint500e system software version 5.3. This issue affects how the sample source is identified at the LIS when using the capillary mode. With this software version, samples run in the capillary mode are incorrectly labeled as arterial when displayed on the LIS, leading to the potential for results to be flagged according to an established arterial range. Capillary sample results are correctly identified as capillary on both the RAPIDPoint 500e system display and the instrument printouts. The issue only affects the new software version 5.3 and only capillary sample mode is impacted. The inability to distinguish specimen sources for blood gas may lead to incorrect diagnoses and management decisions.
Stryker GmbH
The adjustment ring on the device may become loose resulting in the wire tension not being able to be set correctly.
GE HealthCare has become aware of the potential for loss of monitoring on CARESCAPE Canvas 1000, CARESCAPE Canvas Smart Display, and certain versions of CARESCAPE B850 and CARESCAPE B650 monitors if, following the replacement of the CPU timekeeper battery, a mains power loss occurs during active monitoring. In the unlikely event that this occurs, it can result in the displays or monitors not turning on, after the mains power is restored. This can result in a delay in recognizing changes in patient condition until a replacement monitor is connected.
GE HealthCare has become aware of the potential for loss of monitoring on CARESCAPE Canvas 1000, CARESCAPE Canvas Smart Display, and certain versions of CARESCAPE B850 and CARESCAPE B650 monitors if, following the replacement of the CPU timekeeper battery, a mains power loss occurs during active monitoring. In the unlikely event that this occurs, it can result in the displays or monitors not turning on, after the mains power is restored. This can result in a delay in recognizing changes in patient condition until a replacement monitor is connected.
Siemens Medical Solutions USA
Short circuit in the power supply unit (PSU) of the Touch Display may lead to overheating and fire
Due to inadvertently disconnecting grounding cable of ultrasound system could result in electrical shock, electrical interference and/or equipment malfunction.
Siemens Medical Solutions USA
Short circuit in the power supply unit (PSU) of the Touch Display may lead to overheating and fire
Siemens Medical Solutions USA
Short circuit in the power supply unit (PSU) of the Touch Display may lead to overheating and fire
Siemens Medical Solutions USA
Short circuit in the power supply unit (PSU) of the Touch Display may lead to overheating and fire
Siemens Medical Solutions USA
Short circuit in the power supply unit (PSU) of the Touch Display may lead to overheating and fire