🏠 Consumer Products • 1,668 recalls
BioSensory, Inc., of Putnam, Conn.
Carbon dioxide (CO2) pressure sensors inside these products can crack and leak or burst causing the release of CO2. This could cause cracks with sharp edges that could cut a consumer's hand, or direct CO2 discharge could cause a frostbite-like burn to a consumer's hand.
Aqua-Leisure Industries, of Avon, Mass.
The leg straps in the seat of the float can tear, causing children to unexpectedly fall into or under the water, posing a risk of drowning.
MarineTech Products Inc., of White Bear Lake, Minn.
The recalled rope cutters can overheat, posing fire and burn hazards.
Loyal Bedding Inc., of Miami, Fla.
The mattresses sets fail to meet the mandatory federal open flame standard for mattresses, posing a fire hazard to consumers.
Unknown Manufacturer
The brew basket can shift out of alignment allowing hot water to overflow. This poses a scalding and burn hazard to consumers.
Viking Range Corporation, of Greenwood, Miss.
The refrigerator's doors can detach, posing an injury hazard to consumers.
Unknown Manufacturer
The loungewear garments fail to meet children's sleepwear federal flammability standards which require sleepwear, including loungewear, to be either snug-fitting or flame resistant.
Gothic Cabinet Craft Inc., of Maspeth, N. Y.
The bunk beds do not have sufficient headboards, footboards, or guardrails and have gaps between parts of the upper bunk that could allow a child's body to pass through but not a child's head. These bunk beds pose a fall, entrapment, and strangulation hazard to children and violate the spacing requirements of the federal bunk bed safety standard.
Unknown Manufacturer
This toy chair legs can bruise, pinch or cut fingers if caught while folding.
Unknown Manufacturer
The play yard's rocking bassinet attachment can tilt even when secured by straps in the non-rocking mode or can stay tilted without returning to a level sleeping surface while in the rocking mode, causing an infant to roll to the corner or side of the bassinet. The infant can then become wedged in the corner or pressed against the side or bottom of the bassinet, posing a risk of suffocation or positional asphyxiation.
Bush Hog LLC, of Selma, Ala.
The utility vehicle's throttle cable can lock in freezing temperatures. This can cause the engine not to return to idle when the driver takes his or her foot off the accelerator pedal, posing a risk of loss of vehicle control and injury to the driver and passenger.
Unknown Manufacturer
The side supports on these chairs can splinter when weight is placed on them, posing a fall hazard to consumers.
Unknown Manufacturer
One or more rails can collapse unexpectedly, posing a fall or entrapment hazard to young children.
Unknown Manufacturer
While charging the battery, the power source can unexpectedly ignite, posing a fire hazard to consumers.
Evenflo Company Inc., of Miamisburg, Ohio
Plastic caps and metal screws on both sides of the high chair can loosen and fall out, allowing the seatback to suddenly fall back or detach from the high chair. Children can fall backwards or fall out of the high chair and suffer bumps and bruises to the head, broken bones, abrasions, cuts and bruises. Detached hardware also poses a choking hazard to children.
Evenflo Company Inc., of Miamisburg, Ohio
Recline fasteners and metal screws on both sides of the high chair can loosen and fall out, allowing the seatback to detach or recline unexpectedly. Children can fall backwards or fall out of the high chair and suffer bumps and bruises to the head, abrasions, cuts and bruises. Detached hardware also poses a choking hazard to children.
Unknown Manufacturer
The sides of the crib are made of mesh that expands, creating a gap between the side and the crib's mattress if it's not zipped into place, or a gap between the side and an added mattress. A young child can slip into this gap and become entrapped or suffocate. Also, the crib's drop side can fail to fully latch posing a fall hazard to young children.
Unknown Manufacturer
The seat can fall backwards from high chair frame if the booster seat release is unlatched while the child is in the product. Also, the seat back can detach if not fully snapped in place, posing a fall hazard and risk of serious injury to young children.
Unknown Manufacturer
The insulation on the computer's internal wiring can become bent or stripped, causing the wires to overheat while the product is in use. This poses a burn hazard to consumers.
Unknown Manufacturer
A plastic sediment cup attached to the bottom of the fuel valve can crack during shipping and handling and cause fuel leakage or spillage, posing a fire hazard to consumers.