The aerial shells are fused, shaped, and labeled in a way that could cause consumers to unintentionally place them into the launch tube upside down, resulting in a ground-level explosion. Such an explosion can cause serious injuries to consumers in close proximity of the device.
Zhongshan Zhongnam Candle Manufacturer Co., Ltd. of China
Class II - Moderate
The candle has a clamp that is used to extinguish the candle. The clamp does not always sever the wax close to the wick and extinguish the candle as intended. This can allow the flame to continue down into the coiled section of the candle and ignite the entire candle.
When these switches are used in fire or HVAC dampers and heat detectors, they could fail to operate, causing the damper not to close or causing the heat detector not to alarm, if there is a fire.
The glass shades can separate from the light fixture, posing a risk that a consumer could be cut by the broken glass if the shade were to fall and break.
Zhongshan Zhongnam Candle Manufacturer Co., Ltd. of China
Class I - Dangerous
The candle has a clamp (vise) that leads the end of the rope candle at the top. When clamped properly it is supposed to self-extinguish the candle when the burning wick meets the metal clamp (vise). The clamp (vise) does not always sever the wax close to the wick and does not always enable the wick to self-extinguish. This can lead to the flame continuing down into the coiled section of the candle, which can then ignite and cause fire damage.
The log splitter's hydraulic cylinders can have defective rod retention, causing the seals to leak and the rods to detach. This can result in serious injury to the operator, as the rod can rapidly and unexpectedly extend the splitting wedge.
Sea Gull Lighting Products Inc., of Riverside, N.J.
Class III - Low Risk
Due to a manufacturing defect in a component part, the light fixture could fall and strike a person beneath the light fixture. The fixture also poses a laceration risk if the lamp breaks.
When connected to a computer, a static discharge to the sensor can cause the sensor to draw too much current from the computer, causing the sensor to get hot. The sensor can get hot enough to cause a burn to the skin or damage objects in contact with it.
Welds on the frame of these trampolines can break during use, resulting in falls and possible injuries. Additionally, the mounting brackets of the FunRing enclosures have sharp edges, which can cause lacerations.
The necklaces contain high levels of lead. CPSC regulations ban children's products from containing high levels of lead due to the risk of lead poisoning resulting from contact with these products. The necklaces also contain a sharp point, posing a laceration hazard to young children.
Recalled ATVs were assembled with an incorrectly sized mounting bolt under the fuel tank. This could result in fuel leakage, presenting a fire safety hazard and risk of injury or death.